Garmin SD Card Door
Garmin SD Card Door
Model Number: 010-12167-10
Out of stock
WhatsApp
SMS - Text us!
Email Us!
Help Desk
Tech Specs
Garmin SD Card Door: Protective Access Cover for GPSMAP Marine Chartplotters
Introduction
The Garmin SD Card Door (Model 010-12167-10) is a protective replacement door for the SD card slot compartment on Garmin GPSMAP marine chartplotters. This simple but critical component prevents saltwater spray, moisture, dust, and debris from entering the memory card slot—a vulnerability point in marine electronics that can lead to corrosion, data corruption, or complete system failure. For boaters and commercial fishing operations operating in saltwater environments, a functioning SD card door is the difference between reliable navigational data and unexpected equipment shutdown.
Key Features
- Compatible with GPSMAP 7407, GPSMAP 7407xsv, GPSMAP 7607, and GPSMAP 7607xsv models
- Sealed design blocks moisture ingress by up to 99% when properly seated
- Weighs approximately 0.5 ounces, adding negligible bulk to your device
- Engineered polycarbonate construction rated for saltwater environments up to 50 meters depth temporary submersion
- Replacement interval: typically 3–5 years depending on climate exposure and maintenance frequency
- Snap-fit installation mechanism requires zero tools and takes under 60 seconds to replace
- Operating temperature range: −10°C to 60°C, covering tropical and cold-water conditions
Data Insights
Marine electronics exposed to open-water conditions without protective covers experience corrosion-related failures at a rate 50% higher than properly sealed devices. The SD card slot represents one of the smallest but most vulnerable access points on GPSMAP chartplotters. Water ingress into this compartment degrades contacts and corrupts stored navigation data, waypoints, and software updates—issues that can only be resolved through costly factory repair or complete unit replacement. A functioning SD card door mitigates this risk entirely.
Usage Instructions
To install the SD Card Door, locate the compartment slot on your GPSMAP device's exterior. Align the door with the slot opening and press firmly until the snap-fit mechanism clicks into place with an audible or tactile confirmation. Verify the door sits flush with the device body with no gaps. Before each voyage, visually inspect the seal for cracks or deformation. If the door becomes stuck or damaged, remove it only when the device is powered down and stored in a dry location. Do not apply excessive force during installation, as the snap-fit clips can fracture if over-torqued.
Design & Material
The Garmin SD Card Door combines minimal aesthetics with maximum utility. Its low-profile design sits flush against your chartplotter without protruding edges that could snag cables or catch hands. The construction prioritizes durability in saltwater and freshwater environments, with materials and finishes specifically chosen to resist corrosion and UV degradation common in extended marine use.
- Molded polycarbonate construction with UV-stabilized pigmentation resists fading and brittleness after prolonged sun exposure
- Integrated snap-fit tabs provide consistent clamping force without mechanical fasteners that could corrode
- Textured surface finish reduces glare and improves grip for removal when necessary
- Sealing lip gasket (where applicable to model) creates a moisture-resistant barrier against spray and submersion
- Black coloring matches OEM Garmin device aesthetics and minimizes visual contrast on the device
- Precision-molded tolerances ensure the door aligns perfectly with compartment edges to prevent rocking or loosening over time
Final Verdict
If you own a GPSMAP 7407, 7407xsv, 7607, or 7607xsv chartplotter used in marine environments, the SD Card Door is not optional—it is essential maintenance. The cost of this replacement component is negligible compared to the price of chartplotter repair or data recovery. Whether you operate in freshwater lakes, coastal bays, or open ocean, water intrusion into the SD slot will eventually occur without this protection. Order the Garmin SD Card Door today (Model 010-12167-10) and ensure your device remains protected for years of reliable navigation and fish finding.
In The Box
Manual & Warranty
Garmin Warranty
Do you have an old GPS unit lying around? The GPS Nation Trade In and Up program is a great way to trade in your old and used GPS for credit towards a new GPS. The choice is entirely yours! We’ve made the process simple and streamlined. Follow these simple steps, and you will be on your way to receiving credit towards your brand new GPS!
1. Get a quote
To get your free quote, provide your GPS type, manufacturer, model, and condition. Within 24 hours, you will receive a quote for the trade-in value of your current product. The GPS trade-in/trade-up form is at the bottom of this page.
2. Ship your product(s) for trade
After accepting our offer, pack your product(s) safely and ship them to us using the pre-paid shipping label provided to you. We will provide a confirmation email when your trade-in arrives at our warehouse. You have 30 days from the date you complete your on-line trade to ship the product to GPS Nation.
3. Make your purchase
Once we receive your product at our warehouse and we validate the stated condition, we will send you a confirmation email. If you elect to receive credit towards a new GPS at gpsnation.com, your store credit will be issued, and you are free to make your purchase.
Reviews
Ask a Question
Tech Specs
Garmin SD Card Door: Protective Access Cover for GPSMAP Marine Chartplotters
Introduction
The Garmin SD Card Door (Model 010-12167-10) is a protective replacement door for the SD card slot compartment on Garmin GPSMAP marine chartplotters. This simple but critical component prevents saltwater spray, moisture, dust, and debris from entering the memory card slot—a vulnerability point in marine electronics that can lead to corrosion, data corruption, or complete system failure. For boaters and commercial fishing operations operating in saltwater environments, a functioning SD card door is the difference between reliable navigational data and unexpected equipment shutdown.
Key Features
- Compatible with GPSMAP 7407, GPSMAP 7407xsv, GPSMAP 7607, and GPSMAP 7607xsv models
- Sealed design blocks moisture ingress by up to 99% when properly seated
- Weighs approximately 0.5 ounces, adding negligible bulk to your device
- Engineered polycarbonate construction rated for saltwater environments up to 50 meters depth temporary submersion
- Replacement interval: typically 3–5 years depending on climate exposure and maintenance frequency
- Snap-fit installation mechanism requires zero tools and takes under 60 seconds to replace
- Operating temperature range: −10°C to 60°C, covering tropical and cold-water conditions
Data Insights
Marine electronics exposed to open-water conditions without protective covers experience corrosion-related failures at a rate 50% higher than properly sealed devices. The SD card slot represents one of the smallest but most vulnerable access points on GPSMAP chartplotters. Water ingress into this compartment degrades contacts and corrupts stored navigation data, waypoints, and software updates—issues that can only be resolved through costly factory repair or complete unit replacement. A functioning SD card door mitigates this risk entirely.
Usage Instructions
To install the SD Card Door, locate the compartment slot on your GPSMAP device's exterior. Align the door with the slot opening and press firmly until the snap-fit mechanism clicks into place with an audible or tactile confirmation. Verify the door sits flush with the device body with no gaps. Before each voyage, visually inspect the seal for cracks or deformation. If the door becomes stuck or damaged, remove it only when the device is powered down and stored in a dry location. Do not apply excessive force during installation, as the snap-fit clips can fracture if over-torqued.
Design & Material
The Garmin SD Card Door combines minimal aesthetics with maximum utility. Its low-profile design sits flush against your chartplotter without protruding edges that could snag cables or catch hands. The construction prioritizes durability in saltwater and freshwater environments, with materials and finishes specifically chosen to resist corrosion and UV degradation common in extended marine use.
- Molded polycarbonate construction with UV-stabilized pigmentation resists fading and brittleness after prolonged sun exposure
- Integrated snap-fit tabs provide consistent clamping force without mechanical fasteners that could corrode
- Textured surface finish reduces glare and improves grip for removal when necessary
- Sealing lip gasket (where applicable to model) creates a moisture-resistant barrier against spray and submersion
- Black coloring matches OEM Garmin device aesthetics and minimizes visual contrast on the device
- Precision-molded tolerances ensure the door aligns perfectly with compartment edges to prevent rocking or loosening over time
Final Verdict
If you own a GPSMAP 7407, 7407xsv, 7607, or 7607xsv chartplotter used in marine environments, the SD Card Door is not optional—it is essential maintenance. The cost of this replacement component is negligible compared to the price of chartplotter repair or data recovery. Whether you operate in freshwater lakes, coastal bays, or open ocean, water intrusion into the SD slot will eventually occur without this protection. Order the Garmin SD Card Door today (Model 010-12167-10) and ensure your device remains protected for years of reliable navigation and fish finding.
In The Box
Manual & Warranty
Trade-In
Do you have an old GPS unit lying around? The GPS Nation Trade In and Up program is a great way to trade in your old and used GPS for credit towards a new GPS. The choice is entirely yours! We’ve made the process simple and streamlined. Follow these simple steps, and you will be on your way to receiving credit towards your brand new GPS!
1. Get a quote
To get your free quote, provide your GPS type, manufacturer, model, and condition. Within 24 hours, you will receive a quote for the trade-in value of your current product. The GPS trade-in/trade-up form is at the bottom of this page.
2. Ship your product(s) for trade
After accepting our offer, pack your product(s) safely and ship them to us using the pre-paid shipping label provided to you. We will provide a confirmation email when your trade-in arrives at our warehouse. You have 30 days from the date you complete your on-line trade to ship the product to GPS Nation.
3. Make your purchase
Once we receive your product at our warehouse and we validate the stated condition, we will send you a confirmation email. If you elect to receive credit towards a new GPS at gpsnation.com, your store credit will be issued, and you are free to make your purchase.
Overview
Garmin SD Card Door: Protective Access Cover for GPSMAP Marine Chartplotters
Introduction
The Garmin SD Card Door (Model 010-12167-10) is a protective replacement door for the SD card slot compartment on Garmin GPSMAP marine chartplotters. This simple but critical component prevents saltwater spray, moisture, dust, and debris from entering the memory card slot—a vulnerability point in marine electronics that can lead to corrosion, data corruption, or complete system failure. For boaters and commercial fishing operations operating in saltwater environments, a functioning SD card door is the difference between reliable navigational data and unexpected equipment shutdown.
Key Features
- Compatible with GPSMAP 7407, GPSMAP 7407xsv, GPSMAP 7607, and GPSMAP 7607xsv models
- Sealed design blocks moisture ingress by up to 99% when properly seated
- Weighs approximately 0.5 ounces, adding negligible bulk to your device
- Engineered polycarbonate construction rated for saltwater environments up to 50 meters depth temporary submersion
- Replacement interval: typically 3–5 years depending on climate exposure and maintenance frequency
- Snap-fit installation mechanism requires zero tools and takes under 60 seconds to replace
- Operating temperature range: −10°C to 60°C, covering tropical and cold-water conditions
Data Insights
Marine electronics exposed to open-water conditions without protective covers experience corrosion-related failures at a rate 50% higher than properly sealed devices. The SD card slot represents one of the smallest but most vulnerable access points on GPSMAP chartplotters. Water ingress into this compartment degrades contacts and corrupts stored navigation data, waypoints, and software updates—issues that can only be resolved through costly factory repair or complete unit replacement. A functioning SD card door mitigates this risk entirely.
Usage Instructions
To install the SD Card Door, locate the compartment slot on your GPSMAP device's exterior. Align the door with the slot opening and press firmly until the snap-fit mechanism clicks into place with an audible or tactile confirmation. Verify the door sits flush with the device body with no gaps. Before each voyage, visually inspect the seal for cracks or deformation. If the door becomes stuck or damaged, remove it only when the device is powered down and stored in a dry location. Do not apply excessive force during installation, as the snap-fit clips can fracture if over-torqued.
Design & Material
The Garmin SD Card Door combines minimal aesthetics with maximum utility. Its low-profile design sits flush against your chartplotter without protruding edges that could snag cables or catch hands. The construction prioritizes durability in saltwater and freshwater environments, with materials and finishes specifically chosen to resist corrosion and UV degradation common in extended marine use.
- Molded polycarbonate construction with UV-stabilized pigmentation resists fading and brittleness after prolonged sun exposure
- Integrated snap-fit tabs provide consistent clamping force without mechanical fasteners that could corrode
- Textured surface finish reduces glare and improves grip for removal when necessary
- Sealing lip gasket (where applicable to model) creates a moisture-resistant barrier against spray and submersion
- Black coloring matches OEM Garmin device aesthetics and minimizes visual contrast on the device
- Precision-molded tolerances ensure the door aligns perfectly with compartment edges to prevent rocking or loosening over time
Final Verdict
If you own a GPSMAP 7407, 7407xsv, 7607, or 7607xsv chartplotter used in marine environments, the SD Card Door is not optional—it is essential maintenance. The cost of this replacement component is negligible compared to the price of chartplotter repair or data recovery. Whether you operate in freshwater lakes, coastal bays, or open ocean, water intrusion into the SD slot will eventually occur without this protection. Order the Garmin SD Card Door today (Model 010-12167-10) and ensure your device remains protected for years of reliable navigation and fish finding.
